Bread Machine Assembly

Expand All Collapse All

Base Frame + attic
Working from the Back
- Install the Electrical Panel
- Preliminary Electrical & Plumbing you might do this after the first oven-half
  - Plumb PEX pipe all the way up to the front of the machine
  - Build-up Plumbing Assemblies
    - Solenoids
      - Solenoid Assembly Exploded Views PDF
      - Solenoid: 1 side assembled
    - Hot Water Tank
    - Humidifier Tanks
  - Run wires all wires that need to go to the front of the machine (terminate later)
    - Wiring Instructions (new page)
  - General harness layout
- Pan Motor
- First oven-half + some wiring
  - install instructions
    - Use the Forklift to position one oven half as accurately as possible. Fine-tuning may be done by sliding or rocking the oven on forks.
      Install the 1/2-13 hex-head bolts (4x) through the top of the oven and into the attic (use a washer). Leave them somewhat loose.
      Insert the 1/4-20 screws through the lower side of the oven, into the electrical panel. Once all 4 are started, tighten them down.
      Go back and tigten the attic bolts.
  - shipped oven should be pre-insulated, if not: insulation PDF and mirror interior PDF
  - sensors
    - 2 Thermocouples
    - Proofing Sensor
    - Pan Sensor
  - Elements
    - 2 Oven Elements
    - 2 Proofing Elements
    - Pre-Proofing Element
  - Humidifier Tank
- Second oven-half + some wiring
  - sensors
    - 2 Thermocouples
    - Proofing Sensor
  - Elements
    - 2 Oven Elements
    - 2 Proofing Elements
    - Pre-Proofing Element
  - Humidifier Tank
- Humidifier Drain Tank
- Hot water tank + air pump
- Finish Oven
  - Drums
  - Sprockets
  - Chain
  - skin
  - oven doors / glass panels
Working from the Front
- Mixer Pots Just post, no doors or motors
- Batching Table
- Ensure enough wiring and plumbing is completed
- Hoppers include the motor
- Adjust "the stack": pots, batching, hoppers
- HMI and water chambers
  - Plumbing from Below
  - Electrical and Senors from the top
- Finish the Mixer Pots and Hoppers
  - Mixer Pot Shafts and Drive Motor
  - Mixer Pot Doors and stepper motors
  - Mixer Blades
  - Hopper Blades and chain
  - Hopper Sensors
- Forming System
  - Exploded Views PDF
  - Forming System Assembly Video
Independent Assemblies
- Enclosure
- Work Station
  - Shelves
  - Cooling Belts
  - Tilter
  - Tables
In Store
- TV's with stands
- Mast
- Enclosure Glass

Machine Assembly Order